![]() ![]() Glue the two tabs on the roof hinge, then set the roof on the tabs. Make sure the roof is very well folded-I run my fingernail along the edge to really set that crease. Put any flowers or decorations you like on the roof, then fold in half along the score line. The triangle pieces go on the backside of the roof peaks. Put glue on the small triangle pieces of the hinge and secure to the peaks of the house roof. I recommend you allow some space between each piece for a more three-dimensional look.įold the roof hinge so each tab goes in the opposite direction from the others. Fold back the tabs on the rectangular pieces, then slide them into the house from the bottom as you did the staircase. Glue any furniture, accessories, or notes you like to the rectangular pieces. Tip: If you’re going to hide the mouse in his little hole on the back of the card, glue him to the backside of the staircase so he’s visible when looking through the mouse hole. The important thing is to make sure the staircase is parallel to the front door and the tabs are glued on straight across from one another-this ensures the card can fold flat without a problem. In my Fairy House, I put the staircase as far back in the house as it could go, but you can choose to put it anywhere. This ensures the card will fold flat and not buckle later.įold the tabs on the staircase piece, put glue on the tabs, and place in the house from the bottom. Fold it flat and allow it to dry flattened. Put glue on the narrow tab that sticks off the back of the house and attach the left side of the house over it. If you plan to put anything on the walls inside the house, do that now, too.Ĭarefully fold the house along the score lines. I used Spray Mount to get the small pieces to adhere cleanly to the front of the house. ![]() Just be careful not to cover any of the score lines. The little accessories can go wherever they fit. Once your pieces are cut, decorate the front of the house as you see fit. I am also providing text steps below for those who cannot (or do not want to) watch the video. Next, watch the assembly video from start to finish to see how I put the card together. This is what you should see after you click the Make It button. Step 3: Select the Score and Cut layers of each color, then click Attach. Step 2: Change the top layer of each color to Score. Step 1: Upload and Ungroup (orange circle). To do this, upload to your software (I am using Cricut Design Space), ungroup all layers, change the top layer of each color to Score, then select all that color’s layers (both Score and Cut), and click Attach.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |